Tia Portal - Project Transfer; Transfer Via Ethernet - YASKAWA VIPA System MICRO M13-CCF0000 Manual

Configuration with TIA Portal
TIA Portal - Project transfer > Transfer via Ethernet
10.5

TIA Portal - Project transfer

Overview
10.5.1

Transfer via Ethernet

Transfer via Ethernet
Initialization
Transfer
208
6. Navigate to your directory and load the file ...TIA.alxx.
7. Copy the necessary blocks from the library into the "Program blocks" of the Project
tree of your project. Now you have access to the VIPA specific blocks via your user
application.
There are the following possibilities for project transfer into the CPU:
Transfer via Ethernet
n
n Transfer via memory card
n Option: Transfer via MPI
For transfer via Ethernet the CPU has the following interface:
n X3/X4: Ethernet PG/OP channel via an integrated 2-port switch
So that you may the according Ethernet interface, you have to assign IP address parame-
ters by means of the "initialization".
Ethernet PG/OP channel' on page 205
Please consider to use the same IP address data in your project for the CP 343-1.
1. For the transfer, connect, if not already done, the appropriate Ethernet jack to your
Ethernet.
2. Open your project with the Siemens TIA Portal.
3. Click in the Project tree at Online access and choose here by a double-click your
network card, which is connected to the Ethernet PG/OP interface.
4. Select in the Project tree your CPU and click at [Go online].
5. Set the access path by selecting "PN/IE" as type of interface, your network card and
the according subnet. Then a net scan is established and the corresponding station
is listed.
Ä Chapter 10.3 'TIA Portal - Hardware configuration -
HB400 | CPU | M13-CCF0000 | en | 16-47
VIPA System MICRO