Operating Modes; Overview - YASKAWA VIPA System MICRO M13-CCF0000 Manual

VIPA System MICRO
syslibex.wld
Protect.wld
ARM Processor Load
Measurement Cycle Time
Last Value
Maximum Load
Data
Parameter
IP
4.11

Operating modes

4.11.1

Overview

Operating mode STOP
HB400 | CPU | M13-CCF0000 | en | 16-47
n/a
n/a
100 ms
79%
100%
Currently nothing is displayed here.
Currently nothing is displayed here.
Here the IP address data of your Ethernet PG/OP channel are shown.
The CPU can be in one of 3 operating modes:
n Operating mode STOP
n Operating mode START-UP
(OB 100 - restart / OB 102 - cold start *)
n Operating mode RUN
Certain conditions in the operating modes START-UP and RUN require a specific reaction
from the system program. In this case the application interface is often provided by a call
to an organization block that was included specifically for this event.
n The application program is not processed.
n If there has been a processing before, the values of counters, timers, flags and the
process image are retained during the transition to the STOP mode.
Command output disable (BASP) is activated this means the all digital outputs are
n
disabled.
: The yellow LED of the status bar lights up in the STOP state.
n
Deployment CPU M13-CCF0000
Operating modes > Overview
73