Digital Output; Counter - YASKAWA VIPA System MICRO M13-CCF0000 Manual

VIPA System MICRO
9.6.3.2 Parametrization in SPEED7 Studio
9.6.3.2.1 'I/O addresses'
Sub module Input address
DI16/DO12 136
137
9.6.3.2.2 'Inputs'
'Trigger for process
interrupt'
Input delay

9.6.4 Digital output

9.6.4.1 Overview
9.6.4.2 Parametrization in SPEED7 Studio
9.6.4.2.1 'I/O addresses'
Sub module Output address
DI16/DO12 136
137

9.6.5 Counter

9.6.5.1 Overview
HB400 | CPU | M13-CCF0000 | en | 16-47
Access
BYTE
BYTE
Here you can specify a hardware interrupt for each input in groups of 2 channels for the
corresponding edge. The hardware interrupt is disabled, if nothing is selected (default
setting). A diagnostics interrupt is only supported with Hardware interrupt lost.
Here is valid:
n Rising edge: Edge 0-1
n Falling edge: Edge 1-0
The input delay can be configured per channel in groups of 4.
n
n An input delay of 0.1ms is only possible with "fast" inputs, which have a max. input
frequency of 100kHz
input delay for slow inputs is limited to 0.5ms.
n Range of values: 0.1ms / 0.5ms / 3ms / 15ms
n 12xDC 24V, 0.5A
n Sub module 'DI16/DO12'
Ä Chapter 5.5 'Digital output' on page 94
n
Access
BYTE
BYTE
n 4 channels
n Sub module: 'Count'
Ä Chapter 5.6 'Counting' on page 96
n
Configuration with VIPA SPEED7 Studio
Assignment
Digital input I+0.0 ... I+0.7 (X4)
Digital input I+1.0 ... I+1.7 (X4)
Ä Chapter 5.4 'Digital input' on page 90. Within a group, the
Assignment
Digital output Q+0.0 ... Q+0.7 (X5)
Digital output Q+1.0 ... Q+1.3 (X5)
Deployment I/O periphery > Counter
189