Pulse Width Modulation - Pwm - YASKAWA VIPA System MICRO M13-CCF0000 Manual

VIPA System MICRO
Parameter overview
Operating parameters
Integration time
max. counting frequency...
Hardware interrupt
End of measurement

9.6.7 Pulse width modulation - PWM

9.6.7.1 Overview
9.6.7.2 Parametrization in SPEED7 Studio
9.6.7.2.1 'I/O addresses'
Sub module Input address
Count 816
820
824
828
Sub module Output address
Count 816
820
824
828
9.6.7.2.2 'Channel x:'
Operating mode
HB400 | CPU | M13-CCF0000 | en | 16-47
Description
Specify the integration time
Range of values: 10ms ... 10000ms in steps of 1ms
Specify the max. Frequency for the corresponding input
Range of values: 1, 2, 5, 10, 30, 60, 100kHz
Description
Hardware interrupt at end of measurement
n 2 channels
n Sub module 'Count'
Ä Chapter 5.8 'Pulse width modulation - PWM' on page 123
n
Access
DINT
DINT
DINT
DINT
Access
DWORD
DWORD
DWORD
DWORD
Select via 'Channel' the channel and select for pulse width modulation via 'Operating
mode' the operating mode 'Pulse width modulation' . Default values and structure of this
dialog box depend on the selected 'Operating mode' . The following parameters are sup-
ported:
Configuration with VIPA SPEED7 Studio
Deployment I/O periphery > Pulse width modulation - PWM
Assignment
reserved
reserved
reserved
reserved
Assignment
reserved
reserved
reserved
reserved
Assignment
100ms
60kHz
Assignment
de-activated
195