YASKAWA VIPA System MICRO M13-CCF0000 Manual page 173

VIPA System MICRO
1 Standard bus: Object properties
Operating mode: DP master
PROFIBUS address > 1
2 Hardware catalog: CPU 31x
HB400 | CPU | M13-CCF0000 | en | 16-47
4. Open the properties dialog of the DP interface of the CPU by means of a double-
click at 'MPI/DP' .
5. Set Interface: type to "PROFIBUS".
6. Connect to PROFIBUS and preset an address (e.g. 2) and confirm with [OK].
7. Switch at Operating mode to "DP master" and confirm the dialog with [OK].
8. Connect your slave system to this master system by dragging the "CPU 31x" from
the hardware catalog at Configured stations onto the master system and select your
slave system to be coupled.
9. Open the Configuration at Object properties of your slave system.
10. Via double click to the according configuration line you assign the according input
address area on the master CPU to the slave output data and the output address
area to the slave input data.
11. Save, compile and transfer your project to your CPU.
Option: Deployment PROFIBUS communication
from 'Configured stations'
3 DP master system: Object properties
Input area slave CPU = Output area master CPU
Output area slave CPU = Input area master CPU
Deployment as PROFIBUS DP slave
173