YASKAWA VIPA System MICRO M13-CCF0000 Manual page 21

VIPA System MICRO
Wiring procedure
Insert wire
Remove wire
Remove connector
HB400 | CPU | M13-CCF0000 | en | 16-47
1 Labeling on the casing
2 Pin no. at the connector
3 Release area
4 Connection hole for wire
The wiring happens without a tool.
Determine according to the casing labelling the connection position and insert
through the round connection hole of the according contact your prepared wire until
it stops, so that it is fixed.
ð By pushing the contact spring opens, thus ensuring the necessary contact pres-
sure.
The wire is to be removed by means of a screwdriver with 2.5mm blade width.
1. Press with your screwdriver vertically at the release button.
ð The contact spring releases the wire.
2. Pull the wire from the round hole.
By means of a screwdriver there is the possibility to remove the connectors e.g. for
module exchange with a fix wiring. For this each connector has indentations for unlocking
at the top. Unlocking takes place by the following proceeding:
1. Remove connector:
Insert your screwdriver from above into one of the indentations.
Basics and mounting
Wiring > Wiring periphery module
21