YASKAWA VIPA System MICRO M13-CCF0000 Manual page 223

VIPA System MICRO
Event ID
0xEA10
0xEA11
0xEA12
0xEA14
0xEA15
0xEA18
0xEA19
0xEA1A
0xEA20
0xEA21
0xEA22
0xEA23
0xEA24
HB400 | CPU | M13-CCF0000 | en | 16-47
Description
ZInfo3 : Output data width of the plugged module
SBUS: Input periphery address outside the periphery area
ZInfo1 : Periphery address
ZInfo2 : Slot
ZInfo3 : Data width
SBUS: Output periphery address outside the periphery area
ZInfo1 : Periphery address
ZInfo2 : Slot
ZInfo3 : Data width
SBUS: Error at writing record set
ZInfo1 : Slot
ZInfo2 : Record set number
ZInfo3 : Record set length
SBUS: Multiple parametrization of a periphery address (diagnostics address)
ZInfo1 : Periphery address
ZInfo2 : Slot
ZInfo3 : Data width
Internal error - Please contact the hotline!
SBUS: Error at mapping of the master periphery
ZInfo2 : Slot of the master
Internal error - Please contact the hotline!
SBUS: Error at access to the FPGA address table
ZInfo2 : HW slot
ZInfo3 : Table
0: Reading
1: Writing
PK : Not relevant to the user
DatID : Not relevant to the user
Error - RS485 interface is not pre-set to PROFIBUS DP master bus a PROFIBUS DP master is configured
Error - Configuration RS485 interface X2/X3: PROFIBUS DP master is configured but missing.
ZInfo2 : Interface X is faulty configured.
Error - RS485 interface X2 - Value exceeds the limits
ZInfo2 : Project engineering for X2
Error - RS485 interface X3 - Value exceeds the limits
ZInfo2 : Project engineering for X3
Error - Configuration RS485 interface X2/X3: Interface/protocol missing, default settings are used.
ZInfo2 : Project engineering for X2
ZInfo3 : Project engineering for X3
System specific event IDs
223