YASKAWA VIPA System MICRO M13-CCF0000 Manual page 14

Basics and mounting
Mounting > Mounting CPU
Proceeding
2.4.1.2 Mounting with mounting rail
Proceeding
14
You can screw the CPU to the back wall by means of screws via the locking levers. The
happens with the following proceeding:
Dimensions in mm
1. The CPU has a locking lever on the upper and lower side. Pull these levers out-
wards as shown in the figure, until these engage 2x audible.
ð By this openings on the locking levers get visible.
2. Use the appropriate screws to fix your CPU to your back wall. Consider the installa-
tion clearances for the CPU.
ð The CPU is now mounted and can be wired.
Dimensions in mm
1. Mount the mounting rail. Please consider that a clearance from the middle of the
mounting rail of at least 44mm respectively 55mm above and below exists.
VIPA System MICRO
HB400 | CPU | M13-CCF0000 | en | 16-47