Front Panel(S) Installation; Rear Hard Top Removal - Jeep WRANGLER 2020 Owner's Manual

5. Lift the Freedom Top bag into the vehicle
with the hooks and straps facing the back of
the rear seat. Attach the clip at the bottom
of the bag to the child restraint anchorage,
located at the base of the rear seat.
6. Wrap the upper strap around the rear head
restraints and loop the strap through the
buckle. Pull on the strap to tighten the Freedom
Top bag securely against the rear seat.

Front Panel(s) Installation

1. Set the right side panel on the windshield
frame with the locating pin in the front
receiver mounting hole followed by the left
side panel, making sure there is no overhang.
Also, make sure that the panels are sitting
flush with the body.
2. Reinstall the panel(s) using the same steps
for removal in reverse order.
NOTE:
To prevent water leaks, the seals and Freedom
Top Panels should be clear of any dust and
debris prior to re-installation.

Rear Hard Top Removal

1. Remove both front panels.
Refer to "Front Panel(s) Removal"
in this section.
2. Open both front doors.
3. Using the provided #50 Torx head driver
and ratchet, remove the two Torx head
screws that secure the hard top at the
B-pillar (near the top of the front doors).
Step Three
GETTING TO KNOW YOUR VEHICLE
4. Remove the six Torx head screws that
secure the hard top to the vehicle (along the
interior bodyside — three screws on each
side) using the #50 Torx head driver.
Step Four
69
2