Parksense Rear Park Assist - If Equipped; Parksense Sensors; Parksense Warning Display; Parksense Display - Jeep WRANGLER 2020 Owner's Manual

PARKSENSE REAR PARK ASSIST — IF
EQUIPPED
The ParkSense Rear Park Assist system provides
visual and audible indications of the distance
between the rear fascia and a detected obstacle
when backing up (e.g. during a parking
maneuver). Refer to "ParkSense System Usage
Precautions" in this section for limitations of this
system and recommendations.
ParkSense will retain the last system state
(enabled or disabled) from the last ignition cycle
when the ignition is changed to the ON/RUN
position.
ParkSense can be active only when the gear
selector is in REVERSE. If ParkSense is enabled
at this gear selector position, the system will
remain active until the vehicle speed is increased
to approximately 7 mph (11 km/h) or above.
When in REVERSE and above the system's
operating speed, a warning will appear within the
instrument cluster display indicating the vehicle
speed is too fast. The system will become active
again if the vehicle speed is decreased to speeds
less than approximately 6 mph (9 km/h).

ParkSense Sensors

The four ParkSense sensors, located in the rear
fascia/bumper, monitor the area behind the
vehicle that is within the sensors' field of view.
The sensors can detect obstacles from
approximately 12 inches (30 cm) up to 79 inches
(200 cm) from the rear fascia/bumper in the
horizontal direction, depending on the location,
type and orientation of the obstacle.

ParkSense Warning Display

The ParkSense Warning screen is located within
the instrument cluster display. It provides visual
warnings to indicate the distance between the
rear fascia/bumper and the detected obstacle.
Refer to "Instrument Cluster Display" in
"Getting To Know Your Instrument Panel" for
further information.

ParkSense Display

When the vehicle is in REVERSE, the instrument
cluster display will show the park assist ready
system status.
The system will indicate a detected obstacle by
showing a single arc in one or more regions
based on the obstacle's distance and location
relative to the vehicle.
STARTING AND OPERATING
If an obstacle is detected in the center rear
region, the display will show a single solid arc in
the center rear region and will produce a
one-half second tone. As the vehicle moves
closer to the obstacle, the display will show the
single arc moving closer to the vehicle and the
sound tone will change from slow, to fast, to
continuous.
If an obstacle is detected in the left and/or right
rear region, the display will show a single
flashing arc in the left and/or right rear region
and will produce a fast sound tone. As the
vehicle moves closer to the obstacle, the
display will show the single arc moving closer to
the vehicle and the tone will change from fast to
continuous.
Single 1/2 Second Tone/Solid Arc
257
5