Jeep WRANGLER 2020 Owner's Manual page 420

418 MULTIMEDIA
When you are receiving a station that you wish
to commit into memory, press and hold the
desired numbered button on the touchscreen
for more than two seconds or until you hear a
confirmation beep.
The Radio stores up to 12 presets in each of the
Radio modes. Four presets are visible at the top
of the radio screen.
Audio Settings
1. Push the SETTINGS button on the right side
of the radio faceplate. If the settings button
is not present, push the MORE button on
the faceplate, then the Settings button on
the touchscreen.
2. Scroll down and press the Audio button on
the touchscreen to open the Audio menu.
3. The Audio Menu shows the following options
for you to customize your audio settings:
Auto Play — Press the Auto Play button on

the touchscreen to select between ON or
OFF. This feature determines if music
automatically starts playing from a device
when it is first connected to the Media
hub's USB port.
Equalizer — Press the Equalizer button on

the touchscreen to adjust the Bass, Mid
and Treble. Use the + or – buttons on the
touchscreen to adjust the equalizer to your
desired settings. Press the Back Arrow
button on the touchscreen when done.
Balance/Fade — Press the Balance/Fade

button on the touchscreen to adjust the
sound from the speakers. Use the arrow
button on the touchscreen to adjust the
sound level from the front and rear or
right and left side speakers. Press the
Center C button on the touchscreen to
reset the balance and fade to the factory
setting. Press the Back Arrow button on
the touchscreen when done.
Speed Adjust Volume — Press the Speed

Adjusted Volume button on the touch-
screen to select between OFF, 1, 2 or 3.
This will decrease the radio volume rela-
tive to a decrease in vehicle speed. Press
the Back Arrow button on the touch-
screen when done.
Loudness — Press the Loudness button

on the touchscreen to select the Loud-
ness feature. When this feature is acti-
vated, it improves sound quality at lower
volumes.
Clock Settings
1. Push the SETTINGS button on the
faceplate, or push the MORE button on the
faceplate, and then the SETTINGS button
on the touchscreen.
2. Select the Clock and Date button on the
touchscreen.
3. Next, select Set Time to change the time.
4. Select Set Date to change the date.
5. To set the time, select the Seek Up or Seek
Down arrows as appropriate. Select "12 hrs
vs 24 hrs", "AM" or "PM" or select the "Time
Zones" (if equipped).
6. Select the Done button when complete.