Hard Top Front Panel(S) Installation; Removing The Hard Top - Jeep GLADIATOR 2022 Owner's Manual

84 GETTING TO KNOW YOUR VEHICLE
HARD TOP FRONT PANEL(S)
INSTALLATION
1. Set the right side panel on the windshield frame
with the locating pin in the front receiver mounting
hole, followed by the left side panel, making sure
there is no overhang. Make sure that the panels are
sitting flush with the body.
2. Secure the panel(s) using the same steps for
removal in reverse order.
NOTE:
To prevent water leaks, the seals and hard top panels
should be clear of any dust and debris prior to
reinstallation.

REMOVING THE HARD TOP

Use this QR code to access your digital
experience.
1. Remove both front panels
page 81.
2. Open both front doors.
3. Using the provided #50 Torx head driver and
ratchet, remove the two Torx head screws that
secure the hard top at the B-pillar (near the top of
the front doors).
4. If equipped, remove the lower interior soft trim
panel (attached by the hook-and-loop fastener) by
pulling the panel away from the trim.
Scan me
Step Three
Step Four
5. Remove the Torx head fasteners that secure the
hard top to the vehicle: two along the interior body
side, rearward of the back doors, followed by the
four fasteners along the back of the vehicle cab
using the #T50 Torx head driver.
Step Five
1 — Body side Torx Head Fasteners
2 — Vehicle Cab Torx Head Fasteners
6. Locate the wire harness on the left rear inside cor-
ner of the vehicle. To access the harness, remove
the plastic cover by pushing the cover to the side,
and sliding it off.
NOTE:
Do not force open; this will break the plastic cover.