Uconnect Settings; Customer Programmable Features - Uconnect 3 Settings - Jeep WRANGLER 2020 Owner's Manual

378 MULTIMEDIA
Only connect and use trusted media

devices (e.g. personal mobile phones,
USBs, CDs).
Privacy of any wireless and wired
communications cannot be assured. Third
parties may unlawfully intercept information
and private communications without your
consent. For further information, refer to "Data
Collection & Privacy" in your Uconnect Owner's
Manual Supplement or "Onboard Diagnostic
System (OBD II) Cybersecurity" in "Getting To
Know Your Instrument Panel".

UCONNECT SETTINGS

The Uconnect system uses a combination of
buttons on the touchscreen and buttons on the
faceplate located on the center of the instrument
panel. These buttons allow you to access and
change the Customer Programmable Features.
Many features can vary by vehicle.
Buttons on the faceplate are located below
and/or beside the Uconnect system in the
center of the instrument panel. In addition,
there is a Scroll/Enter control knob located on
the right side. Turn the control knob to scroll
through menus and change settings. Push the
center of the control knob one or more times to
select or change a setting.
Your Uconnect system may also have Screen
Off and Mute buttons on the faceplate.
Push the Screen Off button on the faceplate to
turn off the Uconnect screen. Push the button
again or tap the screen to turn the screen on.
Push the Back Arrow button to exit out of a
Menu or certain option on the Uconnect system.
Customer Programmable Features —
Uconnect 3 Settings
Uconnect 3 Buttons On The Touchscreen And Buttons
On The Faceplate
1 — Uconnect Buttons On The Touchscreen
2 — Uconnect Buttons On The Faceplate
Push the Settings button to display the settings
menu screen. In this mode, the Uconnect
system allows you to access all of the available
programmable features.
NOTE:
When pressing the touchscreen buttons, only
one selection can be made at a time.
When making a setting's menu selection, press
the button on the touchscreen to enter the
desired menu screen. Once in the desired
menu, select the preferred setting option by
pressing the corresponding button. Once the
setting is complete, either press the Back
Arrow/Done button on the touchscreen.
Pressing the Up or Down Arrow buttons on the
right side of the screen will allow you to scroll up
or down through the available settings.
NOTE:
All settings should be changed with the ignition
in the "ACC/RUN" position.
The following tables list the settings that may be
found within the Uconnect 3 radio, along with
the selectable options pertaining to each
setting.