Blue Indicator Lights; Gray Indicator Lights - Jeep WRANGLER 2020 Owner's Manual

2WD High Indicator Light — If Equipped With
a Premium Cluster
This light alerts the driver that the
vehicle is in the two wheel drive high
mode.
Hill Descent Control (HDC) Indicator Light — If
Equipped
This indicator shows when the Hill
Descent Control (HDC) feature is
turned on. The lamp will be on solid
when HDC is armed. HDC can only be
armed when the transfer case is in the "4WD
LOW" position and the vehicle speed is less
then 30 mph (48 km/h). If these conditions are
not met while attempting to use the HDC
feature, the HDC indicator light will flash on/off.
Cruise Control Ready Indicator Light — If
Equipped With A Premium Instrument
Cluster
This light will turn on when the speed
control has been turned on, but not
set. Refer to "Speed Control — If
Equipped" in "Starting And Operating"
for further information.
Cruise Control SET Indicator Light — If
Equipped With Base Instrument Cluster
This indicator light will illuminate
when the speed control is set.
Refer to "Speed Control — If Equipped" in
"Starting And Operating" for further
information.
GETTING TO KNOW YOUR INSTRUMENT PANEL

Blue Indicator Lights

High Beam Indicator Light
This indicator light will illuminate to
indicate that the high beam
headlights are on. With the low beams
activated, push the multifunction
lever forward (toward the front of the vehicle) to
turn on the high beams. Pull the multifunction
lever rearward (toward the rear of the vehicle) to
turn off the high beams. If the high beams are
off, pull the lever toward you for a temporary
high beam on, "flash to pass" scenario.

Gray Indicator Lights

Cruise Control Ready Indicator Light — If
Equipped With Base Instrument Cluster
This light will turn on when the speed
control has been turned on, but not
set. Refer to "Speed Control — If
Equipped" in "Starting And Operating"
for further information.
145
3