Jeep WRANGLER 2020 Owner's Manual page 304

302 IN CASE OF EMERGENCY
Jack Warning Label
CAUTION!
Do not attempt to raise the vehicle by jacking
on locations other than those indicated.
1. Remove the spare tire, jack and tools from
the stored location.
2. Loosen (but do not remove) the wheel lug
nuts by turning them to the left one turn
while the wheel is still on the ground.
3. Assemble the jack and jacking tools.
Connect the jack handle driver to the
extension, then to the lug wrench.
Assembled Jack And Tools
4. Operate the jack from the front or the rear of
the vehicle. Place the jack under the axle
tube, as shown. Do not raise the vehicle
until you are sure the jack is fully engaged.
Front Lifting Point
Front Jacking Location
Rear Lifting Point