Jump Starting - Jeep WRANGLER 2020 Owner's Manual

3. Fish the tether strap up through the opening
in the console base.
Tether Strap
4. Press and maintain firm pressure on the
brake pedal.
5. Pull the tether strap up and to the left until
the release lever locks into place in the
vertical position. The vehicle is now out of
PARK (P) and can be moved. Release the
parking brake only when the vehicle is
securely connected to a tow vehicle.
To Reset The Manual Park Release:
1. Pull upward on the tether strap, releasing it
from the "locked" position.
2. Lower the Manual Park Release lever
downward and to the right, into its original
position.
3. Tuck the tether strap into the base of the
console, and reinstall the cover.

JUMP STARTING

If your vehicle has a discharged battery, it can
be jump started using a set of jumper cables
and a battery in another vehicle, or by using a
portable battery booster pack. Jump starting
can be dangerous if done improperly, so please
follow the procedures in this section carefully.
IN CASE OF EMERGENCY
WARNING!
Do not attempt jump starting if the battery is
frozen. It could rupture or explode and cause
personal injury.
CAUTION!
Do not use a portable battery booster pack or
any other booster source with a system
voltage greater than 12 Volts or damage to
the battery, starter motor, alternator or
electrical system may occur.
NOTE:
When using a portable battery booster pack,
follow the manufacturer's operating instruc-
tions and precautions.
305
6