Jeep WRANGLER 2020 Owner's Manual page 15

In this situation, a backup method can be used
to operate the ignition switch. Put the nose side
of the key fob against the START/STOP ignition
button, and push to operate the ignition switch.
Backup Starting Method
To Unlock The Doors And Swing Gate
When "1st Press Of Key Fob Unlocks - Driver
Door" is selected within the Uconnect settings,
the first push and release of the key fob unlock
button will unlock the driver's door only, and a
second time will unlock all the doors and swing
gate. When the key fob unlock button is pushed,
the Illuminated Entry will initiate, and the turn
signal lights will flash twice. Refer to "Uconnect
Settings" in "Multimedia" for further
information.
To Lock The Doors And Swing Gate
Push and release the lock button on the key fob
to lock all doors. The turn signals will flash, and
the horn will chirp once to acknowledge the lock
signal.
Key Fob Battery Replacement
NOTE:
When a key fob battery is low, a warning will be
indicated on the vehicle's instrument cluster,
and the fob LED will no longer illuminate with a
button press.
The recommended replacement battery is
CR2450.
NOTE:
Perchlorate Material – special handling may
apply. See www.dtsc.ca.gov/hazardouswaste/
perchlorate .
GETTING TO KNOW YOUR VEHICLE
1. Remove the back cover of the fob by
inserting a flat-blade screw driver into the
slot on the bottom of the fob. Pry until the
cover unsnaps being careful not to damage
the seal. Proceed counter-clockwise to pry
the remaining snaps until the battery cover
can be removed.
1-3 – Back Cover Pry Points
13
2