Front Panel(S) Installation; Rear Hard Top Removal - Jeep Wrangler 2020 Owner's Manual

4. Unfold the outer flap and zip the Freedom Top bag closed.
Storage Bag Closed
5. Lift the Freedom Top bag into the vehicle with the hooks
and straps facing the back of the rear seat. Attach the clip
at the bottom of the bag to the child restraint anchorage,
located at the base of the rear seat.
6. Wrap the upper strap around the rear head restraints and
loop the strap through the buckle. Pull on the strap to
tighten the Freedom Top bag securely against the rear seat.
GETTING TO KNOW YOUR VEHICLE

Front Panel(s) Installation

1. Set the right side panel on the windshield frame with the
locating pin in the front receiver mounting hole followed
by the left side panel, making sure there is no overhang.
Also, make sure that the panels are sitting flush with the
body.
2. Reinstall the panel(s) using the same steps for removal in
reverse order.
NOTE:
To prevent water leaks, the seals and Freedom Top Panels
should be clear of any dust and debris prior to re-installation.

Rear Hard Top Removal

1. Remove both front panels. Refer to "Front Panel(s)
Removal" in this section.
2. Open both doors.
107
2