Table of Contents
Advertisement
102 GETTING TO KNOW YOUR VEHICLE
Front Panel(s) Installation
1. Set the right side panel on the windshield frame with the
locating pin in the front receiver mounting hole, followed
by the left side panel, making sure there is no overhang.
Make sure that the panels are sitting flush with the body.
2. Secure the panel(s) using the same steps for removal in
reverse order.
NOTE:
To prevent water leaks, the seals and Freedom Top Panels
should be clear of any dust and debris prior to reinstallation.
Rear Hard Top Removal
1. Remove both front panels. Refer to "Front Panel(s)
Removal" in this section.
2. Open both front doors.
3. Using the provided #T50 Torx head driver and ratchet,
remove the two Torx head fasteners that secure the hard
top at the B-pillar (near the top of the front doors) on each
side.
Torx Head Fastener Location — Left Side Shown
Hide quick links:
Advertisement
Table of Contents
