Table of Contents
Advertisement
84
GETTING TO KNOW YOUR VEHICLE
To remove the hard top front panel(s), proceed as
follows:
1. Fold down the sun visor against the windshield.
2. Turn the three L-shaped locks on the left side panel
(one at the front, the rear, and outside), unlocking
them from the roof.
Step Two
3. Unlatch the left side header panel latch located at
the top of the windshield.
Step Three
1 — Header Panel Latched
2 — Unlatched Position
4. Remove the left side panel.
5. Repeat the previous steps to remove the right side
panel.
Hard Top Panel(s) Storage Bag —
If Equipped
The Freedom Top panels storage bag allows you to
store your hard top panels. The storage bag contains
two compartments.
Lay the bag for the Freedom Top panels down so the
loops and hooks are facing upward. Unzip the bag and
fold back the outer flap.
NOTE:
Ensure the front panel latch is closed prior to inserting
the panel into the panels bag.
1. Insert the left side hard top panel into the bag with
the latches facing upward.
2. Unfold the black panel divider (ensure the divider is
lying flat).
3. Insert the right side Freedom Top panel into the bag
with the latches facing downward.
NOTE:
Ensure the front panel latch is closed prior to insert-
ing the panel into the bag.
4. Unfold the outer flap and zip the hard top bag
closed.
Step Four
5. Lift the Freedom Top bag into the vehicle with the
hooks and straps facing the back of the rear seat.
Attach the clip at the bottom of the bag to the child
restraint anchorage, located at the base of the rear
seat.
6. Wrap the upper strap around the rear head
restraints and loop the strap through the buckle.
Pull on the strap to tighten the Freedom Top bag
securely against the rear seat.
HARD TOP FRONT PANEL(S)
INSTALLATION
1. Open the header latch inside the vehicle, and the
three L-shaped locks on each panel.
2. Set the right side panel on the windshield frame
with the locating pin in the front receiver mounting
hole followed by the left side panel, making sure
there is no overhang. Also, make sure that the pan-
els are sitting flush with the body.
3. Reinstall the panel(s) using the same steps for
removal in reverse order.
Advertisement
Table of Contents
