Jeep WRANGLER 2020 Owner's Manual page 214

212 STARTING AND OPERATING
AutoPark
AutoPark is a supplemental feature to assist in
placing the vehicle in PARK should the situations
on the following pages occur. It is a backup
system and should not be relied upon as the
primary method by which the driver shifts the
vehicle into PARK.
The conditions under which AutoPark will
engage are outlined on the following pages.
WARNING!
Driver inattention could lead to failure to

place the vehicle in PARK. ALWAYS DO A
VISUAL CHECK that your vehicle is in PARK
by verifying that a solid (not blinking) "P" is
indicated in the instrument cluster display
and on the gear selector. If the "P" indicator
is blinking, your vehicle is not in PARK. As
an added precaution, always apply the
parking brake when exiting the vehicle.
AutoPark is a supplemental feature. It is not

designed to replace the need to shift your
vehicle into PARK. It is a backup system
and should not be relied upon as the
primary method by which the driver shifts
the vehicle into PARK.
If the vehicle is not in PARK and the driver turns
off the engine, the vehicle may AutoPark.
AutoPark will engage when all of these
conditions are met:
Vehicle is equipped with an 8-speed trans-

mission
Drivers door is ajar or in conditions where

driver door is removed an additional trigger
would be if the driver is off the seat (seat pad
sensor detects driver missing).
Vehicle is not in PARK

Vehicle speed is 0 mph (0 km/h)

Ignition switched from RUN to OFF

NOTE:
For Keyless Enter-N-Go equipped vehicles, The
engine will turn off and the ignition switch will
change to ACC mode. After 30 minutes the igni-
tion switches to OFF automatically, unless the
driver turns the ignition switch OFF.
If the vehicle is not in PARK and the driver exits
the vehicle with the engine running, the vehicle
may AutoPark.
AutoPark will engage when all of these
conditions are met:
Vehicle is equipped with an 8-speed trans-

mission
Drivers door is ajar or in conditions where

driver door is removed an additional trigger
would be if the driver is off the seat (seat pad
sensor detects driver missing).
Vehicle is not in PARK

Driver's door is removed

Vehicle speed is 1.2 mph (2.0 km/h) or less

Driver's seat belt is unbuckled

Driver's door is ajar

Brake pedal is not depressed

The MESSAGE "AutoPark Engaged Shift to P
then Shift to Gear" will display in the instrument
cluster.