Raising The Windshield; Hood; Opening The Hood - Jeep WRANGLER 2020 Owner's Manual

Raising The Windshield

1. Release the strap that secured the
windshield in the lowered position.
2. Raise the windshield.
3. Using the provided #40 Torx head driver,
reinstall the four Torx screws located along
the interior of the windshield. Secure them
until they are snug, being careful not to
cross-thread the screws or overtighten.
Interior Torx Screw Locations
4. Reinstall the windshield wiper arms using
the provided 15 mm socket. First, align the
tips of the blade to the "T" mark in the glass.
Then, while holding the arm in that position,
reinstall the hex nut and tighten until snug.
Be careful not to over-tighten. Repeat for
the other arm.
5. Reinstall the protective caps over the wiper
arm hex bolts and push gently until they
snap into place.
Protective Cap Over Wiper Bolt
6. After completing the steps above:
If your vehicle is equipped with a Soft

Top, reinstall the Door Rails and raise the
top.
If your vehicle is equipped with a Hard

Top, reinstall the Freedom Panels.
GETTING TO KNOW YOUR VEHICLE

HOOD

Opening The Hood

Release both the hood latches.
Hood Latch Locations
Raise the hood and locate the safety latch,
located in the middle of the hood opening. Push
the safety latch to the left side of the vehicle, to
open the hood. You may have to push down
slightly on the hood before pushing the safety
latch. Unhook the support rod from the hood
and insert it into the slot on the front end above
the radiator.
111
2