Jeep WRANGLER 2020 Owner's Manual page 38

36 GETTING TO KNOW YOUR VEHICLE
Using The Retention Straps
1. There are two retention straps located on the
back of the rear seat and two corresponding
wire loops located on the back of each
B-pillar. Open the hook-and-loop fastener on
the strap and thread through the wire loop.
Fold the hook-and-loop fastener over to keep
the seat in the folded position. This should be
done on both sides.
Rear Seat Tumble Position Retention Strap
2. To return the seat to its normal upright
position, reverse these steps.
Removing The Rear Seat
1. Push down on the release bar on each
side, and pull the seat out and away from
the lower bracket.
Release Bar Location
2. Remove the seat from the vehicle.
3. To reinstall the rear seat, just reverse these
steps.
NOTE:
Do not drive the vehicle without reattaching the
rear seat latches.
WARNING!
It is extremely dangerous to ride in a cargo

area, inside or outside of a vehicle. In a
collision, people riding in these areas are
more likely to be seriously injured or killed.
Do not allow people to ride in any area of

your vehicle that is not equipped with seats
and seat belts.
Be sure everyone in your vehicle is in a seat

and using a seat belt properly.
In a collision, you or others in your vehicle

could be injured if seats are not properly
latched to their floor attachments. Always
be sure that the seats are fully latched.