Jeep WRANGLER 2020 Owner's Manual page 112

110 GETTING TO KNOW YOUR VEHICLE
4. Move to the inside of the vehicle and lower
both sun visors.
5. Using the provided #40 Torx head driver,
remove the four Torx screws located along
the interior of the windshield.
Interior Torx Screw Locations
NOTE:
Store all of the mounting bolts in their original
threaded holes and tighten for safekeeping.
6. Lower the windshield gently until it contacts
the footman loop bumpers (if equipped).
Footman Loop Bumpers
1 — Washer Nozzle
2 — Bumper
3 — Footman Loop
7. Secure the windshield by passing a cinch
strap through the footman loops on either
side of the hood and on the windshield
frame. Tighten the strap to secure the
windshield in place.
CAUTION!
Do Not Overtighten! Damage to the
windshield could result.
ACC/FCW Sensor Protective Cover — If
Equipped
Your vehicle may be equipped with a protective
cover that is to be used whenever the
windshield is folded down in order to protect the
ACC/FCW sensor. To install the cover, follow the
instructions below:
1. Secure the top part of the cover so that it
hinges to the header.
2. Swing the cover down and push on it so that
it covers the opening.
3. Check to make sure the cover is secured
properly.
NOTE:
Be sure to remove the cover before returning
the windshield to the normal position. Store the
cover in the cargo area.
Cleaning Instructions
During windshield down applications, dust/dirt
can accumulate in the cover and block the
camera lens. Use a microfiber cloth to clean the
camera lens, module, and inside cover, being
careful not to damage or scratch the module.