Freedom Top Three-Piece Modular Hard Top - If Equipped; Front Panel(S) Removal - Jeep WRANGLER 2020 Owner's Manual

FREEDOM TOP THREE-PIECE MODULAR
HARD TOP — IF EQUIPPED
CAUTION!
The hard top is not designed to carry any addi-

tional loads, such as after-market roof racks,
spare tires, building materials, hunting or
camping supplies, etc. For optional Mopar
accessory roof racks, refer to the Roof Luggage
Rack portion of this Owner's Manual for addi-
tional information.
Do not move your vehicle until the top has

been either fully attached to the front
header, sport bar, and body side or fully
removed.
Failure to follow these cautions may cause
interior water damage, stains or mildew:
It is recommended that the top be free of

water prior to panel removal. Removing the
top, opening a door or lowering a window
while the top is wet may allow water to drip
into the vehicle's interior.
CAUTION! (Continued)
The hard top assembly must be positioned

properly to ensure sealing. Improper instal-
lation can cause water to leak into the
vehicle's interior.
Careless handling and storage of the

removable roof panels may damage the
seals, causing water to leak into the
vehicle's interior.
The front panel(s) must be positioned prop-

erly to ensure sealing. Improper installation
can cause water to leak into the vehicle's
interior.

Front Panel(s) Removal

NOTE:
The left side panel must be
removed before removing the
right side panel.
1. Fold down the sun visor against the
windshield.
2. Turn the three L-shaped locks on the left
(Continued)
side panel (one at the front, the rear, and
outside), unlocking them from the roof.
GETTING TO KNOW YOUR VEHICLE
Roof Panel Lock Locations - Left Panel Shown
3. Unlatch the left side header panel latch
located at the top of the windshield.
Header Panel Latch Locations
1 — Header Panel Latches
2 — Unlatched Position
67
2