Hard Top Front Panel(S) Installation; Removing The Hard Top - Jeep GLADIATOR 2023 Owner's Manual

4. Unfold the outer flap and zip the hard top bag closed.
Step Four
5. Store the Freedom Top panels bag in a safe location.
H T F P (
ARD OP RONT ANEL S
I
NSTALLATION
1. Set the right side panel on the windshield frame with
the locating pin in the front receiver mounting hole,
followed by the left side panel, making sure there is
no overhang. Make sure that the panels are sitting
flush with the body.
2. Secure the panel(s) using the same steps for removal
in reverse order.
NOTE:
To prevent water leaks, the seals and hard top panels
should be clear of any dust and debris prior to
reinstallation.
R T
EMOVING
Use this QR code to access your digital
experience.
1. Remove both front panels
page 88.
Ú
2. Open both front doors.
3. Using the provided #50 Torx head
driver and ratchet, remove the
two Torx head screws that secure the hard top at
the B-pillar (near the top of the front doors).
)
4. If equipped, remove the lower interior soft trim panel
(attached by the hook-and-loop fastener) by pulling
the panel away from the trim.
H T
HE ARD OP
Step Three
GETTING TO KNOW YOUR VEHICLE
Step Four
5. Remove the Torx head fasteners that secure the hard
top to the vehicle: two along the interior body side,
rearward of the back doors, followed by the four
fasteners along the back of the vehicle cab using the
#T50 Torx head driver.
Step Five
1 — Vehicle Cab Torx Head Fasteners
2 — Body side Torx Head Fasteners
91
2