Door Frame Installation Two Door Models - If Equipped; Soft Top Two Door Models - If Equipped - Jeep WRANGLER 2020 Owner's Manual

Door Frame Installation Two Door Models —
If Equipped
1. Carefully place the front door rail in the
rubber seal at the top of the windshield,
and line up the holes for the Torx head
screws (two for each door).
2. Swing the frame bracket around the side
of the rail, and insert the screws from
underneath. Tighten with #40 Torx head
driver until they are snug, being careful not
to cross-thread the screws or overtighten.
Refer to the table below for the appropriate
torque specifications for the door rail screws.
Step Two
Torque
Specification
Maximum
For Torx
Screws
8.8 in-lbs 11.0 in-lbs
12 N· m 15 N·m
CAUTION!
Do not overtighten the screws. You can strip
the screws if they are overtightened.
GETTING TO KNOW YOUR VEHICLE
SOFT TOP TWO DOOR MODELS — IF
EQUIPPED
Minimum
The fabric quarter windows and fabric top

6.6 in-lbs
are designed only for protection against the
9 N·m
elements. Do not rely on them to contain
occupants within the vehicle or to protect
against injury during an accident.
Remember, always wear seat belts.
Make sure hands and fingers are clear of

all pinch points when installing and
removing the soft tops. The lift assist mech-
anism and side bows may cause serious
injury if fingers or hands get caught in
between.
75
WARNING!
2