Hard Top Front Panel S Installation; Removing The Hard Top - Jeep Wrangler Owner's Manual

62 GETTING TO KNOW YOUR VEHICLE
NOTE:
Ensure the front panel latch is closed prior to inserting the
panel into the bag.
4. Unfold the outer flap and zip the hard top bag closed.
Step Four
5. Lift the Freedom Top bag into the vehicle with the
hooks and straps facing the back of the rear seat.
Attach the clip at the bottom of the bag to the child
restraint anchorage, located at the base of the rear
seat.
6. Wrap the upper strap around the rear head restraints
and loop the strap through the buckle. Pull on the
strap to tighten the Freedom Top bag securely
against the rear seat.
H T F P (
ARD OP RONT ANEL
I
NSTALLATION
1. Open the header latch and the three L-shaped locks
on each panel.
2. Set the right side panel on the windshield frame with
the locating pin in the front receiver mounting hole
followed by the left side panel, making sure there is
no overhang. Also, make sure that the panels are
sitting flush with the body.
3. Reinstall the panel(s) using the same steps for
removal in reverse order.
NOTE:
To prevent water leaks, the seals and hard top panels
should be clear of any dust and debris prior to reinstal-
lation.
R
EMOVING
1. Remove both front panels
2. Open both front doors.
) 3. Using the provided #50 Torx head driver and ratchet,
S
remove the two Torx head screws that secure the
hard top at the B-pillar (near the top of the front
doors).
T H T
HE ARD OP
page 59.
Ú
Step Three