10. Secure the wire harness to the body side
by plugging it into the receptacle and
reengaging the locking tab.
Securing The Wire Harness
11. Secure the washer hose by snapping it into
the top of the body side receptacle.
Securing The Washer Hose
Secured Wire Harness And Washer Hose
12. Lower the rear window, and close the swing
gate.
13. Remove the hard top from the vehicle.
Place the hard top on a soft surface to
prevent damage.
CAUTION!
The removal of the Freedom Top requires four
adults located on each corner. Failure to
follow this caution could damage the
Freedom Top.
GETTING TO KNOW YOUR VEHICLE
Rear Hard Top Installation
NOTE:
If the door frames are installed from soft top
usage, they must be removed prior to installa-
tion of the hard top. Refer to "Door Frame" in
this section for installation procedures.
1. Inspect the hard top seals for damage and
replace if necessary.
2. Install the hard top using the same steps for
removal in reverse order.
Make sure that the hard top is sitting flush
with the body at the sides and check to en-
sure that there is a uniform gap between
the lift glass and hard top.
NOTE:
The Torx fasteners that attach the hard top to
the body should be torqued as follows using the
provided #50 Torx head driver and ratchet:
Hard top to B-pillar: 119 in-lb +/- 23 in-lb
(13.5 N·m +/- 2.7 N·m)
Hard top to J-rail: 154 in-lb +/- 30 in-lb
(17.5 N·m +/- 3.5 N·m)
71
2