Jeep WRANGLER 2020 Owner's Manual page 33

2. Remove the hinge pin screws from the
upper and lower outside hinges (using a
#T50 Torx head driver).
NOTE:
The hinge pin screws and nuts can be stowed in
the rear cargo tray located under the rear load
floor.
Hinge Pin Screw
3. Slide the front seat(s) fully forward.
4. Pry open and remove the plastic wiring
access door from the bottom of the B-Pillar.
Wiring Access Door
5. Unplug the wiring connector.
NOTE:
Squeeze the tab on the base of the wiring
harness. This will unlock the connector tab,
allowing the wiring connector to be unplugged.
Wiring Connector
GETTING TO KNOW YOUR VEHICLE
6. Remove the check screw from the center
door check (using a #T40 Torx head driver).
Door Check (Attached)
7. With the door open, lift the door with the
help of another person, to clear the hinge
pins from their hinges and remove the door.
To reinstall the door(s), perform the previous
steps in the reverse order.
NOTE:
The upper hinge has a longer pin, which can be
used to assist in guiding the door into place
when reinstalling.
31
2