Accessory Drive Belt Inspection - Jeep WRANGLER 2020 Owner's Manual

324 SERVICING AND MAINTENANCE
Engine Air Cleaner Filter Inspection and
Replacement
Follow the recommended maintenance
intervals as shown in the Maintenance
Schedule in this section.
Engine Air Cleaner Filter Removal
1. Loosen the retainers from the air cleaner
cover using a suitable tool.
Air Cleaner Filter Cover
1 — Retainers
2 — Air Filter Cover
2. Lift the air cleaner cover to access the air
cleaner filter.
Air Cleaner Filter Cover
3. Remove the air cleaner filter element from
the housing assembly.
Air Cleaner Filter
1 — Air Cleaner Filter Inspection Surface
2 — Air Cleaner Filter
Engine Air Cleaner Filter Installation
NOTE:
Inspect and clean the housing if dirt or debris is
present before replacing the air filter element.
1. Install the air cleaner filter element into the
housing assembly with the air cleaner filter
inspection surface facing downward.
2. Tighten air cleaner cover retainers using a
suitable tool.

Accessory Drive Belt Inspection

WARNING!
Do not attempt to inspect an accessory

drive belt with vehicle running.
When working near the radiator cooling fan,

disconnect the fan motor lead. The fan is
temperature controlled and can start at any
time regardless of ignition mode. You could
be injured by the moving fan blades.
You can be badly injured working on or

around a motor vehicle. Only do service work
for which you have the knowledge and the
proper equipment. If you have any doubt
about your ability to perform a service job,
take your vehicle to a competent mechanic.