Table of Contents
Advertisement
HARD TOP FRONT PANEL(S)
INSTALLATION
1. Set the right side panel on the windshield frame
with the locating pin in the front receiver mounting
hole, followed by the left side panel, making sure
there is no overhang. Make sure that the panels are
sitting flush with the body.
2. Secure the panel(s) using the same steps for
removal in reverse order.
NOTE:
To prevent water leaks, the seals and hard top panels
should be clear of any dust and debris prior to
reinstallation.
REMOVING THE HARD TOP
Use this QR code to access your digital
experience.
1. Open both front doors.
2. Using the provided #50 Torx head
driver and ratchet, remove the two
Torx head screws that secure the hard top at the
B-pillar (near the top of the front doors).
3. If equipped, remove the lower interior soft trim
panel (attached by the hook-and-loop fastener) by
pulling the panel away from the trim.
Scan me
Step Two
Step Three
GETTING TO KNOW YOUR VEHICLE
4. Remove the Torx head fasteners that secure the
hard top to the vehicle: two along the interior body
side, rearward of the back doors, followed by the
four fasteners along the back of the vehicle cab
using the #T50 Torx head driver.
Step Four
1 — Vehicle Cab Torx Head Fasteners
2 — Body side Torx Head Fasteners
5. Locate the wire harness on the left rear inside cor-
ner of the vehicle. To access the harness, remove
the plastic cover by pushing the cover to the side,
and sliding it off.
NOTE:
Do not force open; this will break the plastic cover.
83
2
Advertisement
Table of Contents
