Starting And Operating; Starting The Engine; Manual Transmission - If Equipped; Automatic Transmission - If Equipped - Jeep WRANGLER 2020 Owner's Manual

210

STARTING THE ENGINE

Before starting your vehicle, adjust your seat,
adjust both inside and outside mirrors, and
fasten your seat belts.
WARNING!
When exiting the vehicle, always remove

the key fob from the ignition and lock your
vehicle.
Never leave children alone in a vehicle, or

with access to an unlocked vehicle.
Allowing children to be in a vehicle unat-

tended is dangerous for a number of
reasons. A child or others could be seriously
or fatally injured. Children should be
warned not to touch the parking brake,
brake pedal or the gear selector.
Do not leave the key fob in or near the

vehicle, or in a location accessible to chil-
dren. A child could operate power windows,
other controls, or move the vehicle.

STARTING AND OPERATING

WARNING! (Continued)
Do not leave children or animals inside

parked vehicles in hot weather. Interior
heat build-up may cause serious injury or
death.
Manual Transmission — If Equipped
Apply the parking brake, place the gear selector
in NEUTRAL, and press the clutch pedal before
starting the vehicle. This vehicle is equipped
with a clutch interlocking ignition system. It will
not start unless the clutch pedal is pressed to
the floor.
Four-Wheel Drive Models Only
In 4L mode, if the vehicle is stalled, the engine
will start regardless of whether or not the clutch
pedal is pressed to the floor. This feature
enhances off-road performance by allowing the
vehicle to start when in 4L without having to
press the clutch pedal. The "4WD Low Indicator
Light" will illuminate when the transfer case has
been shifted into this mode.
(Continued)
Automatic Transmission — If Equipped
Start the vehicle with the gear selector in the
PARK position (vehicle can also be started in
NEUTRAL). Apply the brake before shifting to
any driving range.

Normal Starting

To Turn On The Engine Using The ENGINE
START/STOP Button
1. The transmission must be in PARK or
NEUTRAL.
2. Press and hold the brake pedal while
pushing the ENGINE START/STOP button
once.
3. The system takes over and attempts to start
the vehicle. If the vehicle fails to start, the
starter will disengage automatically after
10 seconds.
4. If you wish to stop the cranking of the
engine prior to the engine starting, push the
button again.