Jeep WRANGLER 2020 Owner's Manual page 16

14 GETTING TO KNOW YOUR VEHICLE
2. Remove the depleted battery by inserting a
small flat-blade screwdriver into the battery
removal slot and sliding the battery forward
and up being careful not to damage the
electronic board underneath.
Battery Replacement
3. Install the new battery into the key fob,
making sure the positive (+) side is facing
up. Slide the battery until it is seated
securely below the tabs.
4. Reassemble the back cover making sure it
is properly aligned before snapping it back
in place.
Programming Additional Key Fobs
Programming the key fob may be performed by
an authorized dealer.
NOTE:
Once a key fob is programmed to a vehicle, it
cannot be repurposed and reprogrammed to
another vehicle.
Request For Additional Key Fobs
NOTE:
Only key fobs that are programmed to the
vehicle electronics can be used to start and
operate the vehicle. Once a key fob is
programmed to a vehicle, it cannot be
programmed to any other vehicle.
WARNING!
Always remove the key fobs from the

vehicle and lock all doors when leaving the
vehicle unattended.
Always remember to place the ignition in

the OFF mode.
Duplication of key fobs may be performed at an
authorized dealer. This procedure consists of
programming a blank key fob to the vehicle
electronics. A blank key fob is one that has
never been programmed.
NOTE:
When having the Sentry Key Immobilizer

System serviced, bring all vehicle keys with
you to an authorized dealer.
Keys must be ordered to the correct key cut

to match the vehicle locks.