Four-Wheel Drive Operation - Jeep WRANGLER 2020 Owner's Manual

226 STARTING AND OPERATING
Operation
To activate AutoStick mode, move the gear
selector into the MANUAL (M) position (beside
the DRIVE position). The current transmission
gear will be displayed in the instrument cluster.
In AutoStick mode, you can use the gear
selector (in the MANUAL position) to manually
shift the transmission. Tapping the gear
selector forward (-) while in the MANUAL (M)
position will downshift the transmission to the
next lower gear. Tapping the selector rearward
(+) will command an upshift.
In AutoStick mode, the transmission will shift up
or down when (+/-) is manually selected by the
driver, unless an engine lugging or overspeed
condition would result. It will remain in the
selected gear until another upshift or downshift
is chosen, except as described below.
The transmission will automatically down-

shift as the vehicle slows (to prevent engine
lugging) and will display the current gear.
The transmission will automatically down-

shift to FIRST gear when coming to a stop.
After a stop, the driver should manually
upshift (+) the transmission as the vehicle is
accelerated.
You can start out, from a stop, in FIRST or

SECOND gear (or THIRD gear, in 4L range).
Tapping (+) (at a stop) will allow starting in
SECOND gear. Starting out in SECOND or
THIRD gear can be helpful in snowy or icy
conditions.
If a requested downshift would cause the

engine to over-speed, that shift will not occur.
The system will ignore attempts to upshift at

too low of a vehicle speed.
Holding the gear selector in the (-) position

will downshift the transmission to the lowest
gear possible at the current speed.
Transmission shifting will be more noticeable

when AutoStick is enabled.
The system may revert to automatic shift

mode if a fault or overheat condition is
detected.
NOTE:
When Hill Descent Control is enabled, AutoStick
is not active.
To disengage AutoStick mode, return the gear
selector to the DRIVE position. You can shift in or
out of the AutoStick position at any time without
taking your foot off the accelerator pedal.
WARNING!
Do not downshift for additional engine
braking on a slippery surface. The drive
wheels could lose their grip and the vehicle
could skid, causing a collision or personal
injury.
FOUR–WHEEL DRIVE OPERATION
WARNING!
Failure to engage a transfer case position
completely can cause transfer case damage or
loss of power and vehicle control. You could
have a collision. Do not drive the vehicle unless
the transfer case is fully engaged.