Removing The Mpcs With Adapter Card Before Installing An Mx2020 Router - Juniper MX2020 Hardware Manual

Figure 96: Removing an SFB
0
OK/FAIL

Removing the MPCs with Adapter Card Before Installing an MX2020 Router

To remove an MPC with an adapter card (ADC):
1. Have ready an antistatic mat for the MPC with an ADC. Also have ready rubber safety caps for each
MPC using an optical interface on the MPC that you are removing.
2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
an approved site ESD grounding point. See the instructions for your site.
3. Open both the ejector handles simultaneously to unseat the both the MPC and the ADC.
4. Grasp the handles, and slide the MPC along with the ADC straight out of the card cage halfway.
5. Place one hand around the front of the MPC with the ADC and the other hand under MPC to support
it. Slide the MPC along with the ADC completely out of the chassis, and place it on the antistatic mat
or in the electrostatic bag.
19
254