Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
6.6
Setting clock
⇒ "6.6.1 Setting clock, up to MY 2015", page 144
⇒ "6.6.2 Setting clock, starting from MY 2016", page 145
6.6.1
Setting clock, up to MY 2015
Vehicles without an information display
The clock is set using the operating buttons -1- and -3-. The button
-1- is used for selecting the information to be set, i. e minutes or
hours.
The selected information is set with the button -3-.
Vehicles with an information display
On vehicles with an information display the clock is set in the
menu "Time":
– Switch on ignition.
– Hold the button -2- on the windscreen wiper lever pressed for
longer than 1 second. This will show the information display of
the »MAIN MENU«. Observe the instructions
– Select option »Setup« with the button -1-, briefly press this
button and further select the option »Time«.
Here the time can be set and switched over between a 24 h or 12
h display as well as between summer and winter time.
Note
After the ignition is switched on, the information display shows
♦
the function which was last selected before switching off the
ignition. Use the button -2- in order to return to the main menu.
If the menu in the information display cannot be called up by
♦
pressing the button -2-, proceed as follows:
Messages of the Škoda information system appear in the in‐
♦
formation display. For example a symbol can appear here for
the door warning, a too low fuel or engine oil level etc.
In this case the button -1- must be pressed.
♦
If several messages appear, the button must be pressed again
♦
for each individual message until no further message is dis‐
played.
The function which was last selected before switching off the
♦
ignition is shown in the information display. Use the button
-2- in order to return to the main menu.
144
6. Electrical System
⇒ page 144
.