Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
•
the tyre structure is damaged
•
the vehicle is loaded on one side
•
the wheels on an axle are heavily loaded (e.g when operating
a trailer, on steep gradients).
•
Snow chains are installed
•
an emergency wheel is installed
•
a wheel is changed on an axle.
A calibration is required at each pressure change, at each tyre
change (also change from front to rear) and after working on the
chassis in the workshop, which has an influence on the tyre in‐
spection display.
The tyre inspection display has a warning light in the dash panel
insert.
Calibration for vehicles with the button in the centre console
– Switch on ignition.
– Press and hold down the tyre pressure loss indicator button.
The warning light for the tyre inflation display in the dash panel
insert lights up as long as the button is pressed.
Performing the calibration is confirmed by an informative tone and
when the warning light in the dash panel insert goes out.
Calibration for vehicles with infotainment radio/navigation
Perform the calibration of the tyre inspection display according to
the vehicle specification.
The vehicles are equipped with different infotainment radio/navi‐
gation. For operation refer to the ⇒ operating instructions info‐
tainment radio/navigation .
– Switch on ignition.
– In Infotainment radio / navigation, select the
then the "vehicle status" button, and then the
button.
tire
– Further select the button
The calibration starts herewith.
– Continue by referring to the read-out on the display.
140
CAR
Check
SET (with tyre symbol))
button, and
.