Connect Diagnostic Unit - Skoda Rapid NH 2013 Maintenance, Workshop Manual

6.6.2 Setting clock, starting from MY 2016
Set the clock with the buttons on the instrument cluster
Control button -1-
0.0/SET
– Switch on ignition.
– Press the button -1-
The lettering -time- lights up in the display -2- of the dash panel
insert.
An hour display is shown in the display -2- at the same time as
the lettering -time-.
– Release the button -1-
ately by repeatedly pressing the button -1-
After setting the hour, wait for approx. 2 s until the minute display
is shown.
– Release the button -1-
priately by repeatedly pressing the button -1-
After performing the setting, wait a short period of time until the
display switches back to the normal display.
Set clock for vehicles with infotainment radio/navigation
Set the clock and the date according to the vehicle specification.
The vehicles are equipped with different infotainment radio/navi‐
gation. For operation refer to the ⇒ operating instructions info‐
tainment radio/navigation .
– Switch on ignition.
– Select the following in the infotainment radio/navigation:
"Device settings" (button
SETUP
or
"Vehicle settings".
– Further select the button
– Then proceed by referring to the read-out on the display.
Here you can also set the date, daylight saving time, time zone,
time and date format.
6.7

Connect diagnostic unit

Connect the diagnostic unit to the diagnostic connector.
Note
♦ The event memory is queried and further diagnostic proce‐
dures and functions are performed using the vehicle diagno‐
sis, measurement and information system -VAS- together with
the corresponding diagnostic cable ⇒ Vehicle diagnostic test‐
er.
Follow the instructions on the diagnostic device display to
♦
continue.
is used to set the clock.
, and hold for approx. 5 s.
0.0/SET
, and set the hours appropri‐
0.0/SET
0.0/SET
, and set the minutes appro‐
0.0/SET
) and in addition button
MENU
.
time and date
Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
.
.
0.0/SET
145
6. Electrical System