5.7.4
Check the tyre pressure (including
spare wheel) and if necessary correct
pressure, up to MY 2016
Special tools and workshop equipment required
♦ Tyre pressure tester e.g. VAS 5216
Caution
♦ During pre-sales inspection, the tyres on the front and rear
axles must be inflated to the "partial load" value in columns
-A- of the tyre pressure tables
The pressure values are also indicated on a sticker, which is
attached to the inside of the fuel filler flap.
The tyre pressure values apply only to the tyres when cold.
Do not reduce the higher tyre pressure of warm tyres.
After each tyre pressure correction the calibration of the "tyre
inspection
display"
⇒ "5.11 Tyre pressure monitoring indicator: calibration",
page 139
.
Tyre pressure values in the spare wheel
Caution
The full-size spare tire should have the highest possible tire
pressure, which is intended for the particular vehicle type.
The temporary spare wheel (emergency wheel) must have the
required tire pressure of 420 kPa / 4.2 bar).
⇒ page 134
.
must
be
performed
Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
133