Skoda Rapid NH 2013 Maintenance, Workshop Manual page 168

Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
• The status LED -2- of the ERA Glonass system is then lit green
at the latest within approx. 2 minutes after ignition is switched
on.
If the status LED -2- of the ERA Glonass system is green, the
system is ready.
If the status LED -2- of the ERA Glonass system is read even after
approx. 2 minutes since the ignition was switched on (the system
is no ready):
WARNING
If the ERA Glonass system is not ready after approx. 2 minutes
since ignition was switched on, repair is necessary.
– Query GSM network status with the vehicle diagnosis, meas‐
urement and information system -VAS-
⇒ "6.7 Connect diagnostic unit", page 145
– To do this, select the following on the diagnostics device:
→"Body" → "Electrical System" → "01- Self-diagnosable sys‐
tems" → "0075 Emergency call module and communication
unit" → "Emergency call module functions" → "0075 - Read
measured values" and next "Network_Connectivity".
– Query event memory with the vehicle diagnosis, measurement
and information system -VAS-
⇒ "6.7 Connect diagnostic unit", page 145
In the event of an error:
– Perform repair and if necessary replace the OCU control unit
( control unit for emergency call module and communication
unit - J949- ) ⇒ Electrical System; Rep. gr. 91 ; Mobile online
services .
If reception is too weak or there is no reception:
– Change vehicle location (e.g. go to open area with better re‐
ception).
After changing the vehicle location (or after repair is complete):
– Switch off ignition, wait approx. 2 minutes and then switch on
ignition again.
– Check colour the status LED -2- of ERA Glonass system
again.
• The status LED of the ERA Glonass system must be green at
the latest within approx. 15 minutes after ignition is switched
on.
If the status LED of the ERA Glonass system is still read even
after approx. 15 minutes since the ignition was switched on: the
system is not ready.
– Create a DISS ticket (i.e. a technical repair request, DISS
message) and send it to the Technical Service Centre (TSC).
164
6. Electrical System
.
.