Skoda Rapid NH 2013 Maintenance, Workshop Manual page 74

Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
– Check the engine oil level again and top up with oil if neces‐
sary.
– Wait at least 3 minutes after topping up the oil again before
inspecting the oil level again.
– Install the noise insulation.
Note
The oil level must not be above the -Max- marking to avoid dam‐
age to the catalytic converter. See Inspecting engine oil level
⇒ "3.9 Inspecting engine oil level", page 62
3.10.4 Vehicles with a diesel engine; draining
and topping up with engine oil, starting
from MY 2016
– Take off cap.
– Remove the noise insulation.
– Replace engine oil filter
⇒ "3.4.4 Replacing engine oil filter for diesel engines starting
from MY 2016", page 58
Caution
No oil must enter the area between the oil sump and the oil
sump noise insulation sleeve during the oil change.
The oil sump noise insulation sleeve can be fully taken in with
the engine oil in this case.
Carefully release the oil sump noise insulation sleeve from the
oil sump.
– Release the oil sump noise insulation sleeve from the oil sump
as follows:
Cutting the noise insulation sleeve to release it.
– Using a suitable tool, cut the oil sump noise insulation sleeve
-1- at the narrowest point -arrow- of the connection for the oil
level and oil temperature sender - G266- -2-.
– Carefully route the pipe for the oil level and oil temperature
sender - G266- behind the oil sump noise insulation sleeve.
There is no need to disconnect the connector -2-.
Releasing the noise insulation sleeve without cutting
70
.
.