Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
Note
After replacing the particle filter, carry out"adaption of the engine
control unit after replacing particle filter", i.e. set the limit value for
the ash mass to -0-.
3.18.2
Checking the Otto particulate filter - pet‐
rol engines
– Check that all lines and encoders for the particle filter are con‐
nected and secure.
– Check particle filter for leaks, damage and secure fit.
Note
As part of checking the particle filter, the fill level of the particle
filter volume is queried.
– Select "Targeted functions" and further "engine" and then start
"check volumetric efficiency of the particle filter volume" ⇒ Ve‐
hicle diagnostic tester.
– If the ash mass limit is reached or exceeded (negative test
result), the particle filter must be replaced ⇒ Relevant Engine;
Rep. gr. 26 .
Replacing the particle filter is a repair measure.
Note
After replacing the particle filter, carry out"adaption of the engine
control unit after replacing particle filter", i.e. set the limit value for
the ash mass to -0-.
106