Skoda Rapid NH 2013 Maintenance, Workshop Manual page 155

– Hold the button -2- on the windscreen wiper lever pressed for
longer than 1 second. This will show the information display of
the »MAIN MENU«. Observe the instructions
– Select the »Setup« option with the -1- button, briefly press this
button and then select the »service interval option (Service.
Info.)« and the option »Reset«.
WARNING
This work sequence cannot be carried out on vehicles, for
which no service message or only a pre-warning was displayed
on the display of the dash panel insert.
♦ Vehicles with variable service intervals (QI6) by default
are automatically recoded to fixed service intervals as a
result of this procedure.
♦ The coding can only be reset to variable service intervals
(QI6) with the -VAS- if the following conditions are met
⇒ "6.11 Changing the code of the service intervals", page
157 .
6.10.3 Resetting service interval display from
MY 2014 to MY 2015
WARNING
Vehicles from MY 2014 are equipped with a two-channel serv‐
ice interval display with a different service message.
This two-channel service interval display must be reset in 2
steps.
Reset service interval display with the vehicle diagnosis, meas‐
urement and information system -VAS-
The service interval display can also be reset with the buttons in
the dash panel insert ⇒ page 152
Reset service interval display with the vehicle diagnosis, meas‐
urement and information system -VAS-
When resetting the service interval display with vehicle diagnosis,
measurement and information system -VAS- , note the following
instructions:
⇒ page 144
⇒ page 151 .
.
Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
.
151
6. Electrical System