Skoda Rapid NH 2013 Maintenance, Workshop Manual page 163

Caution
The inclination value is marked on the top of the headlight
housing. The headlights must be set to this value.
The inclination value in "%" does not have a minus symbol.
Inspecting the headlight beam setting
Halogen headlights:
– Check whether the light beam -1- generates the light-dark limit
on the dividing line -2- of the control surface when the low
beam is switched on.
– Check whether the inflection point -4- runs between the left
horizontal part and the right rising part of the light/dark limit
and through the central mark -3- on the vertical. The light core
of the light beam must be located to the right of the vertical
line.
Note
To make it easier to determine the kink -4-, alternately cover
♦
and release the left half of the headlight (in the direction of
motion) Afterwards, check the low beam again.
Once the low beam light has been correctly set, the centre of
♦
the light beam of the main beam must be positioned on the
central mark -3-.
The headlight setting on the control screen with adjusting line
♦
15° -1- is analogous to the headlight setting on the control
screen without this adjusting line.
To prevent an incorrect headlight adjustment, the adjusting
♦
line 15° -1- must not be observed however.
Xenon headlights:
– Check whether the deepest part of the light beam -1- gener‐
ates the light-dark limit on the dividing line -2- of the control
surface when the low beam is switched on.
– Check whether the inflection point -4- runs between the left
horizontal part and the right rising part of the light/dark limit
and through the central mark -3- on the vertical.
Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
159
6. Electrical System