Skoda Rapid NH 2013 Maintenance, Workshop Manual page 107

– Correctly fit locating lug -2- with the guide -arrow- in the area
of the retaining lugs -3- at the fuel filter -1-.
– Clip retaining ring -2- onto the fuel filter -1-.
– Press the fuel filter -1- into the bracket as far as it goes.
WARNING
When pressing in the fuel filter -1- into the mounting bracket
ensure that the retaining lugs -3- lock into place in the provided
recesses of the retainer ring -2-.
– Vent the fuel system as follows:
– Connect fuel feed line at fuel filter inlet. Do not connect fuel
line from the fuel filter output to the high pressure pump.
– Connect a suitable auxiliary hose at the fuel filter and guide it
into a catch pan.
– Plug entry to the fuel line to the high pressure pump with a plug
(e.g. using round material).
• Vehicle must be refuelled.
– Connect the diagnosis device VAS , switch on the ignition and
fill and vent the high pressure pump/fuel system as follows:
– Select on the diagnosis device: "Guided functions" And then
→ "Control fuel pump" ⇒ Vehicle diagnostic tester,
– Follow the instructions on the diagnostic device display to
continue.
Note
Exercise special care.
♦
The fuel pump is controlled, the catch pan is filled with fuel.
♦
After venting:
– Remove suitable fuel hoses from the fuel filter.
– Remove the plug from the entry point on the fuel line to the
high pressure pump.
– Connect the fuel line to the high pressure pump at the fuel filter
outlet.
– Check the fuel system for leak-tightness (visual inspection).
Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
103