Replace Fuel Filter - Petrol Engines; Checking Particle Filter - Skoda Rapid NH 2013 Maintenance, Workshop Manual

– Push the fuel filter -1- out of the holder.
– Remove the fuel filter -1- from the fuel filter holder in upward
direction.
Installing
– Insert a new filter into the fuel filter holder.
– Attach the socket boxes to the filter connection until the de‐
tents audibly latch.
♦ Make sure the fuel hoses fit tightly.
♦ Do not kink the fuel hoses when routing.
♦ If necessary, push the fuel hoses back into the holders.
WARNING
To avoid the high-pressure pump (very low tolerances) running
dry, and ensure fast starting of the engine after replacing the
filter, the fuel system must be filled/bled before starting the en‐
gine for the first time!
– Fill/bleed the fuel system ⇒ Rep. gr. 23 ; injection system; Fill/
bleed the fuel system .
3.17

Replace fuel filter - petrol engines

Replace fuel filter ⇒ Rep. gr. 20 ; Fuel filter; Removing and in‐
stalling fuel filter .
3.18

Checking particle filter

⇒ "3.18.1 Checking diesel particulate filter - diesel engines", page
105
⇒ "3.18.2 Checking the Otto particulate filter - petrol engines",
page 106
3.18.1 Checking diesel particulate filter - diesel
engines
– Check that all lines and encoders for the particle filter are con‐
nected and secure.
– Check particle filter for leaks, damage and secure fit.
Note
As part of checking the particle filter, the fill level of the particle
filter volume is queried.
– Select "Targeted functions" and further "engine" and then start
"check volumetric efficiency of the particle filter volume" ⇒ Ve‐
hicle diagnostic tester.
– If the ash mass limit is reached or exceeded (negative test
result), the particle filter must be replaced ⇒ Relevant Engine;
Rep. gr. 26 .
Replacing the particle filter is a repair measure.
Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
105