Skoda Rapid NH 2013 Maintenance, Workshop Manual page 60

Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
Vehicles with replacement oil filter element
Remove replacement oil filter element
– Unscrew the screw cap for the oil filter into the height of the
lug -a- -arrow- (or by around 3 revolutions if the lug is no longer
present) and allow it to remain in this position for a few minutes
so that the oil can flow out of the oil filter element.
Note
When the screw cap is fully removed for the oil filter without a
♦
wait time, the oil will flow into the AC generator.
Cover the AC generator with a cloth before removing the screw
♦
cap for the oil filter.
Make sure none of the engine oil drops onto the poly V-belt.
♦
– Completely unscrew the screw cap for the oil filter, remove.
– Light knock the screw cap for the oil filter with the oil filter el‐
ement holder -1- on a fixed base -3- (e.g. a wooden plate)
-arrow-.
This loosens the oil filter insert -2-.
– Place the screwdriver carefully in the groove -arrow- of the
screw cap for the oil filter and plug off the O-ring.
Install new replacement oil filter element
– Replace O-rings -2-.
– Insert new oil filter element -3-.
– Screw in the screw cap for oil filter -1- and tighten to 25 Nm.
– After filling with oil, run engine until it is at operating tempera‐
ture and inspect for tightness.
– Install engine cover at top .
56