Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
Check timing belt for:
♦ Tears or splits -A-, cross-sectional fractures
♦ Lateral catches -B-
♦ Fraying or chunking -C-
♦ Crack in the base tooth -D-
♦ Separation of layers (timing belt housing, cords)
♦ Traces of oil and grease
WARNING
If any of the above mentioned defects or shortcomings are
found, the timing belt must most definitely be replaced! Major
engine damage can thus be avoided.
Replacing the timing belt is a repair measure.
The re-installation of the toothed belt guard occurs in reverse or‐
der.
Tightening torque
Screw for toothed belt guard
3.8.2
Inspecting toothed belt for coolant pump
drive for wear and running
Work procedure
– Loosen hose clamps -1, 2- and remove air guide pipe.
– Expose air guide hoses on the air guide pipe.
60
Nm
8