Note
When removing the inspection pin, ensure that the grinder
♦
does not move otherwise this can result in an incorrect meas‐
urement.
On certain vehicles (e.g. with steel rims), where the inspection
♦
pin - T40139A- does not reach/rests against the brake disc/
backing plate, check the brake pad thickness with the inspec‐
tion pin - T40139A- from the inside of the wheel.
Wear limit of front disc brake pads
The wear limit -a- is reached at a pad thickness of 7 mm, including
backing plate.
If the thickness of the pad is less than 7 mm including backing
plate, always replace the brake pads on both sides (repair meas‐
ure)
– Inspect also the brake discs for damage (scores, tears) and
wear (minimum thickness) ⇒ Brake systems; Rep. gr. 00 .
The brake disc change is a repair measure.
Note
After replacing the brake pads depress brake pedal firmly several
times when the vehicle is stationary to ensure the brake pads are
properly seated in their normal operating position.
Rear disc brake pads
The wear limit -a- is reached at a pad thickness of 7.6 mm, in‐
cluding backing plate.
If the thickness of the pad is less than 7.6 mm including backing
plate, always replace the brake pads on both sides (repair meas‐
ure)
– Inspect also the brake discs for damage (scores, tears) and
wear (minimum thickness) ⇒ Brake systems; Rep. gr. 00 .
The brake disc change is a repair measure.
Note
After replacing the brake pads depress brake pedal firmly several
times when the vehicle is stationary to ensure the brake pads are
properly seated in their normal operating position.
Rear drum brake linings
Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
117
5. Chassis